When the warm, moist air from below rises into the cold roof space; condensation begins as the air temperature drops to the 'dew point' or as the warm air comes into contact with any of the cold surfaces in the roof.
Roof framing must be designed to hold up a structural load including what is called dead load, its own weight and the weight of the roof covering, and additional loading called the environmental load such as snow and wind. Flat roofs may also need to be designed for live loads if people can walk on them. In the United States, building codes specify the loads in pounds per square foot which vary by region. The load and span (distance between supports) defines the size and spacing of the rafters and trusses.
In high wind areas, such as where a cyclone or hurricane may make landfall, the main engineering consideration is to hold the roof down during severe storms. Every component of the roof, as of course the rest of the structure, has to withstand the uplift forces of high wind speeds. This is accomplished by using metal ties fastened to each rafter or truss. This is not normally a problem in areas not prone to high wind or extreme weather conditions.
Condensation within the roof space is much more of a problem today due to: much less fortuitous ventilation due to tighter building envelopes with high performance windows and door and no chimneys leading. This tighter envelope means the air temperature in buildings has risen, the warmer the air in the building is, the more water vapour the air can carry.
☑ triple wall polycarbonate sheets☑ wickes triple wall polycarbonate sheet☑ roofing solutions☑ 10mm triple wall polycarbonate sheet☑ triple wall polycarbonate sheet cut to size☑ triple wall polycarbonate roofing sheets