There are four main types of roofers: shinglers, who primarily install shingles, shakes, tiles, and other nail-on products on roofs with 5:12 pitches or above; metal roofers, who focus on metal panels; single-ply or "flat" roofers, who focus on roofs such as single-ply or foam roofs; and "hot" roofers, who work using tar-based products. It is not uncommon, however, for companies to have their roofers service multiple styles and types of roofing; and certain manufactures will allow only pre-approved installers, thus making these four roofer types limiting. As per the application areas, roofing contractors can be categorized as Industrial or commercial roofers, Factory Shed roofers, Residential Roofers, Commercial roofers. Based on the types of the materials, roofing can be classified as terrace roofing, metal roofing, polycarbonate roofing, steel roofing, PVC roofing, skylight roofing. Pre-engineered companies installs roofing.
A simple rafter roof consists of rafters that the rafter foot rest on horizontal wall plates on top of each wall.The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple. Depending on the roof covering material, either horizontal laths, battens, or purlins are fixed to the rafters; or boards, plywood, or oriented strand board form the roof deck (also called the sheeting or sheathing) to support the roof covering. Heavier under purlins or purlin plates are used to support longer rafter spans. Tie beams, which may also serve as ceiling joists, are typically connected between the lower ends of opposite rafters to prevent them from spreading and forcing the walls apart. Collar beams or collar ties may be fixed higher up between opposite rafters for extra strength. The rafters, tie beams and plates serve to transmit the weight of the roof to the walls of the building.
The roof framing may be interrupted for openings such as a chimney or skylight. Chimneys are typically built with a water diverter known as a cricket or saddle above the chimney. Flashing is used to seal the gap between the chimney and roofing material.
Roof space ventilation is needed to combat condensation within the roof space, leading to interstitial condensation within the roof fabric; this can lead to serious structural damage, wet or dry rot, as well as ruining the insulation in the roof spec.
☑ lightweight plastic sheets☑ lightweight corrugated plastic sheets☑ lightweight flexible plastic sheets☑ lightweight clear plastic sheets☑ perforated tiles☑ lightweight strong plastic sheets☑ lightweight plastic roof sheets☑ lightweight rigid plastic sheets☑ cornice moldings☑ lightweight hard plastic sheets